Gutter cleaning, repair and new gutters in Bloomingdale, GA

When to clean gutters in Bloomingdale

The first fall frost comes around November 30 in a typical year here, and the last spring frost around March 2 (median dates, NOAA normals). Booking the fall cleaning after the first frost, once the trees over the roof are bare, catches the season’s drop in one visit; the spring cleaning comes after the pollen and catkins are down.

When to clean gutters explains how the trees over a roof change the schedule.

Gutter and downspout size for Bloomingdale rain

The short, hard downpour is what a gutter is sized for. In Bloomingdale the five-minute rain expected about once in ten years falls at 9.88 inches an hour (NOAA Atlas 14 Volume 9). At that rate one 2-by-3-inch downspout drains about 730 square feet of roof and one 3-by-4-inch downspout about 1,460, by the rule in the Copper Development Association’s design handbook. Try your own roof in the gutter and downspout calculator, which starts from this figure.

The houses in Bloomingdale

Half the homes in Bloomingdale were built by 1986, 39% before 1980 (ACS 2020–2024). Houses that age have often had their gutters replaced once already; if not, the original runs and the boards behind them deserve a close look.

67% of households own their home, and 82% of homes are detached houses. If an association maintains the exterior, the gutters may be its job rather than yours; check before calling.

Hiring in Georgia

Georgia does not require a state contractor license for gutter work: the licensing board lists “Gutters and Downspouts” among the traditional specialty trades, which under O.C.G.A. § 43-41-17 need no residential or general contractor license when the work stays within the specialty. With no state license to look up, ask for proof of liability insurance, the city or county business license, and a written quote.

Source: Georgia Secretary of State, Traditional Specialty Contractors.