Gutter cleaning, repair and new gutters in Rollingwood, TX

When to clean gutters in Rollingwood

The first fall frost comes around December 3 in a typical year here, and the last spring frost around February 20 (median dates, NOAA normals). A fall cleaning set for the weeks after that frost, when the branches over the house are bare, gets the year’s leaves in one trip; a spring visit follows once the pollen and catkins have come down.

When to clean gutters explains how the trees over a roof change the schedule.

Gutter and downspout size for Rollingwood rain

The short, hard downpour is what a gutter is sized for. In Rollingwood the five-minute rain expected about once in ten years falls at 9.60 inches an hour (NOAA Atlas 14 Volume 11). At that rate one 2-by-3-inch downspout drains about 750 square feet of roof and one 3-by-4-inch downspout about 1,500, by the rule in the Copper Development Association’s design handbook. Try your own roof in the gutter and downspout calculator, which starts from this figure.

The houses in Rollingwood

Half the homes in Rollingwood were built by 1981, 48% before 1980 (ACS 2020–2024). Houses that age have often had their gutters replaced once already; if not, the original runs and the boards behind them deserve a close look. On a house built before 1978, replacing more than 20 square feet of painted fascia or trim falls under the EPA’s lead-safe rule, so ask whether the crew is certified.

90% of households own their home, and 100% of homes are detached houses. If an association maintains the exterior, the gutters may be its job rather than yours; check before calling.

Hiring in Texas

Licensing for gutter work differs from state to state; ask a contractor in Rollingwood which license or registration they hold in Texas, and for proof of liability insurance. Hiring a gutter contractor